Rechercher dans les propriétés de la page

Rechercher dans les propriétés de la page

Entrer soit une page et une propriété, ou seulement une propriété, pour récupérer toutes les valeurs affectées.

Affichage de 6 résultats à partir du n°1.

Voir (20 précédentes | 20 suivantes) (20 | 50 | 100 | 250 | 500).


    

Liste de résultats

  • '''1)''' Connect the pump to the hose. '''''1)''' Connect the pump to the hose. '''2)''' Place it right at the back of the second 60L container. '''3)''' Pour 15 to 20L of water into the container. '''Caution: '''In order to retain the cascading effect from the biofilter, the liquid in the container should not exceed the 40L level. To avoid damage to the pump through turning it on without water, do not fill under the 10L level.ut water, do not fill under the 10L level.  +
  • '''1)''' Drill 7 or 8 small holes in the b'''1)''' Drill 7 or 8 small holes in the bottom of one of the 60L containers Place the container on top of the bowl (biofilter) '''3)''' Fill the worm compost with the following: 1st layer: porous rocks (base layer- made of bedding material suitable for drainage) and straw (this first layer is for earthworm reproduction). 2nd layer: organic waste and 20 to 40 earthworms 3rd layer: Straw (2nd lot of bedding material for earthworm reproduction) '''4)''' Cover the worm composter with a lid.4)''' Cover the worm composter with a lid.  +
  • '''1)''' Drill a hole the same diameter as'''1)''' Drill a hole the same diameter as your hose in the centre of your bowl. '''2)''' Drill smaller holes in the bottom of the bowl.This allows the liquid to flow from the bowl to the container. '''3)''' Place the bowl over the container. '''4)''' Feed the pipe through the hole in the bowl and check that the pump is still submerged under the water at the bottom of the container. '''5)''' Fill the bowl with the straw, porous rocks and fungi. (You can buy these from GHE - General Hydroponics Europe, 10g per 10L or approximately 2 teaspoons). '''Note: '''You can also use rotting organic matter.Decomposers (micro-organisms) can be found under rotting branches and can be recognised by a film of whitish mould. '''6)''' Putting a piece of open-weave canvas on the end of the pipe allows the water to circulate in the pipe without having to bypass the rock or the straw.ut having to bypass the rock or the straw.  +
  • * It is best to feed the worm compost in * It is best to feed the worm compost in phases: a 10L bucket with lid can be used to collect the waste (approximately 1 week’s worth) before adding it into the system. Then cover with a bed of 1cm (approx.) of straw. This is used as a shelter for the worms and is an area where they can reproduce before the next application. * In order that waste breaks down correctly, the following conditions are required at the same time: - Temperature and humidity should be sufficiently high: worm compost should stay moist - even pour a small amount of water over it if necessary. Don’t hesitate to throw in the remains from your teapot or coffee-maker (worms love caffeine!). Water (without added salt) from boiled rice can also be a treat for earthworms. - PH value must be more or less neutral: The PH value of all the different foods added must be evened out (e.g. avoid only pasta) - Good aeration (add layer of straw (1cm approx) after adding food waste) * The leachate (brown liquid) can be easily retrieved by emptying the contents of the reservoir. Using a funnel, pour the leachate into bottles but allow it to aerate as it is a living environment. Without air, organic matter will ferment and therefore gives off an offensive smell which may be very unpleasant. * You will get your first harvest 15 days after the system has been in place. Apply as follows to plants: 10ml per 10 litres; monitor and increase if required (if leaves are pale green, then increase the dosage) are pale green, then increase the dosage)   +
  • 1) Worm Composter ''2)''' Biofilter '''3)''' Biofilter Reservoir (receptacle and pump)  +
  • Vous pouvez télécharger une fiche pédagogique créée par le Low-tech Lab dans la partie "Fichiers" du tutoriel (onglet au niveau de la section "Outils-Matériaux")  +