Rechercher dans les propriétés de la page

Rechercher dans les propriétés de la page

Entrer soit une page et une propriété, ou seulement une propriété, pour récupérer toutes les valeurs affectées.

Affichage de 8 résultats à partir du n°1.

Voir (20 précédentes | 20 suivantes) (20 | 50 | 100 | 250 | 500).


    

Liste de résultats

  • - Cut the dowels, the PVC tube and the pri- Cut the dowels, the PVC tube and the prism to the required length. - Also cut two polystyrene cylinders 14cm in diameter and extrude a 3x3cm prism down the centre. - Fix the 8mm diameter stud to the empty coil using two washers and two 8mm nuts. - Insert the PVC tube around the stud and secure it with another 8mm nut - Drill a 4mm diameter hole in the prism at a distance of 3cm. - Fix to the main wooden board using a screw (whatever the reference), then add the pieces of polystyrene, the coil and finally the 4mm diameter stud which is fixed around the prism using two washers and two 4mm nuts. All you have to do is turn the spool by hand using the handle to collect the filament. using the handle to collect the filament.  +
  • - If necessary, drill holes in the bracket- If necessary, drill holes in the bracket so that the holes are co-axial with the holes in the heating part of the nozzle. -Fasten the heating part of the nozzle to the bracket using the bolts. -Drill the nozzle to a diameter of 1.75 mm. -Screw this nozzle into the heating section -Screw the bracket to the wood using the wood screws (the nozzle must be in line with the band made by the bottle).in line with the band made by the bottle).  +
  • Make a countersunk hole in the board (the Make a countersunk hole in the board (the chamber will be 5mm deep and 20mm in diameter, and the diameter of the hole will be equal to that of the threaded rod). This hole corresponds to the centre of the arc of the 3D printed part. The bedroom will be below the board) Cut the threaded rod to a length of 20cm. Screw the threaded rod with the M4 nuts onto the board at the centre of the arc of the previously 3D printed part. The threaded rod must not extend beyond the underside of the board. Insert a nut on the threaded rod and then a washer to hold the pipe in place on the rod. Cut the pipe to a length 3cm shorter than the top of the threaded rod Fit the last washer and nut to tighten the PVC pipe.
    er and nut to tighten the PVC pipe. <br/>  +
  • Print the part in STL Link to 3D file: https://www.thingiverse.com/thing:6482361  +
  • Use M4 CHC screws and M4 nuts to screw in the bearings The screw heads are below the 3D printed part Put a washer around the screw head and nut. <br/>  +
  • Using the 4 wood screws on the board  +
  • Wiring it all up (see photo) Arduino Code : <br/>  +
  • You'll need a 50cm x 70cm board. Required thickness 10mm.  +