Tutorial de Nomade des Mers | Catégories : Outils
With this bottle cutter it possible to make a plastic rope from plastic bottles. It is simple to make and can be carried everywhere.
With this bottle cutter it possible to make a plastic rope from plastic bottles. It is simple to make and can be carried everywhere.
découpe, bouteille, bottle, cutter, fil, plastique, plastic, rope, NomadeDesMers en fr 1
The piece of wood used in this tutorial is 22 x 2 x 2 cm. You can use one a bit larger but you do not need to use a longer one.
Draw a line about 6 cm long, well centered. Cut along this line. The bottom of the slot must be straight
Draw a transverse line, perpendicular to the previous slot. The depth of this slot must be less than the width of the cutter blade.
The cutter blade fits in this slote and it defines the width of the wire you will cut. For a 4mm wide wire, make the cut at 4mm from the bottom of the longitudinal slot.
Insert the blade into the slot, back outside. Place the washers to block the blade without hiding the slot. Mark the center of the holes for drilling. Drill the holes. The drill bit should have a diameter slightly smaller than the diameter of the screws. Screw in the screws and washers.
The bottle cutter is ready, it is now necessary to prepare a bottle and to cut it: Cut the bottom of the bottle. The cut must be clean and straight. Cut out a primer with scissors. Insert the primer and cut the wire.
The rope from plastic bottles is more or less resistant depending on its thickness and the nature of the plastic.
This rope has two great advantages: it is heat-shrinkable and ages well outdoors.
It can be used to make lattices (for staking plants) or to hang objects. It is also possible to weave it.
Whatever its resistance, this wire is not standardized and cannot be used to support or ensure the safety of people.
Le fil plastique issu de bouteille est plus proche de la sangle que de la ficelle de part son profil plat. Tout comme pour les sangles, tous les nœuds ne fonctionnent pas sur ce support et certains sont plus adaptés que d'autres.
Voici une liste des nœuds fonctionnant parfaitement avec le fil plastique:
Pour fermer un anneau ou pour rabouter deux brins:
Pour créer une boucle à une extrémité:
Yes
Vous avez entré un nom de page invalide, avec un ou plusieurs caractères suivants :
< > @ ~ : * € £ ` + = / \ | [ ] { } ; ? #