Cuiseur à pellets/en

SZUMILO David

https://wiki.lowtechlab.org/wiki/Cuiseur_%C3%A0_pellets/en

Dernière modification le 27/06/2024

Difficulté

Medium Moyen

Durée

4 hour(s) heure(s)

Coût

250 EUR (€)

Description

Cooker using pellets, walnut shells and probably other types of bulk material, with a 3-hour autonomy.

Sommaire

granulés, granules, pellets, cuiseur, bois

---

Introduction

Cooker for community, event or fairground catering using pellets, wood or certain bulk materials

Because of our geographical location, we use walnut shells to make it work. We still need to do measurements with RCW (large cross-section, otherwise the fire will burn too quickly) and fruit pits (olives, cherries, etc.).

Unlike traditional pellet stoves fed by an endless screw, the pellets are poured into a reservoir and lit from above using a fire starter: this principle requires no electronics or electricity.

The large tank provides 3 hours of autonomy, the small tank 1 hour.

You can build in a 1/1 gastronorm (28L, for cooking inside or as a bain-marie), or place a ceramic hob (plancha or crêpe pan) or a vat (2/1 48L gastronorm, used for pasteurisation, sterilisation and bain-marie) on top.

You can also replace the support plates with a metal garden table into which you fit the fireplace.

After several years in existence, the model presented on this site has evolved into a version without the purchase of materials, as the latter were a hindrance to the creation of this cooker. A TUTO is available to present the new version.

Modifications have been made to this model: the 4cm gastronorm shown in the photos and diagrams below has been replaced by a 15cm gastronorm, bringing the bowl closer to the fire and increasing power.

1. 
2. 
3. 
4. 

Matériaux

• 1 gastronorme 1/1 20cm
• 1 gastronorme 1/1 15cm
• 1 90° elbow 125mm
• 1 alumina tube 500X125mm
• 4 sheets 2MM
• 1 community can 150mm
• 1 tube 330X150mm
• 4 square tubes 15X15X600MM
• 1 pin
• Self-drilling screws

Doesn't include the bowl on top

Outils

Grinder, sheet metal shears, drill and screwdriver

https://www.dusoleildansnosassiettes.com/plans-cuiseur-collectif-pellets

Étape 1 - Sheet metal cutting

• Cut out or have cut out by a boilermaker the 4 sheets according to the attached drawings: 1, 2, 3 (refer to the link at the bottom of the page if the plans are not opened)

• Screw the feet on

Étape 2 - Gastronorm cutting

• Découper à la cisaille à tôle les gastronormes (trou du conduit : un peu plus de 125mm et trou du réservoir : un peu plus de 150mm)

Étape 3 - Confection des réservoirs

• Assembler le grand réservoir à pellet à l'aide des autoforantes, réaliser la colerette à l'aide de la cisaille à tôle puis percer le petit et le grand ainsi :

- Trous d'air inférieurs : 30 trous de 8mm

- Trous d'air supérieurs : 15 trous de 8mm

en fr 1 Published