Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- For maximum efficiency, it is ideal to sea … For maximum efficiency, it is ideal to seal the pipes. In SERTA, the non-movable part is poured into the concrete that forms the tank cover. What is important is that the extension, through which the water will enter the circuit, does not touch the bottom of the reservoir, but is nevertheless close enough to be able to draw from the deepest part of the basin, and that the whole system is rigid enough to facilitate pumping. It is advisable to position the entire system before fixing it.sition the entire system before fixing it. +
- Glue all the pieces then once dry, drill a … Glue all the pieces then once dry, drill and screw in the middle of the 50mm-50mm coupling. You can also nail (see picture) very well by drilling with a smaller diameter. This allows the ball to lift sufficiently to allow water to pass through, while preventing it from clogging the other end. /!/ Make sure the ball is on the right side!/ Make sure the ball is on the right side! +
- Once the verification is done, the assembl … Once the verification is done, the assembly can begin. You simply have to glue the elements with PVC glue and check the sealing at the end. How to glue ? - Grind with fine sandpaper the parts to be assembled - Clean with a cloth soaked in paint stripper. - Apply the glue at the inlet of the female part and on the entire male part. - Immediately engage fully, without twisting. - Wipe off glue burrs. The drying time is about 1h, but if the water is to be consumed, it is advisable to wait between 12h and 24h for the toxic solvents to disperse.nd 24h for the toxic solvents to disperse. +
- The principle of operation of this pump is … The principle of operation of this pump is very simple. When the piston is raised, a vacuum is created. It will attract water from the pool through the anti return system from below. The other valve is in the other direction, the water from the outlet is not sucked in. When the piston is lowered, an overpressure is created, which will close the bottom check valve, and open the other valve. The water can then come out. This type of pump is called a "delivery pump". type of pump is called a "delivery pump". +
- Without sticking the pieces together, the purpose of this step is to check the material. Nest the elements as shown in the following diagram: You can even test the operation. To optimize : areas surrounded in blue should be as short as possible. +
Français
English
Deutsch
Español
Italiano
Português