Tawashi

Tutorial de avatarCharlotte | Catégories : Hygiène

Tawashi 53723707 268554654073514 828667975023198208 n.jpg

Este tutorial pretende dar otra vida a tu tela o trozos de tela viejos haciendo una esponja ecológica.

Difficulté
Très facile
Durée
15 minute(s)
Coût
0 EUR (€)
Autres langues :
English • ‎español • ‎français • ‎العربية
Licence : Attribution (CC BY)

Introduction

Piensa en apartar tus telas estropeadas para darles una segunda vida. Incluso puedes hacerlo también con un hilo de tela. Luego podrás utilizarlo para lavar tu vajilla o a ti mismo dependiendo del material que utilices. Un material suave como el algodón es bueno para el cuerpo, la camiseta también funciona, sólo los vaqueros y los pantalones no son recomendables.

Video d'introduction

Matériaux

Medias viejas gruesas, leotardos o calcetines

Tela vieja

Outils

Una tabla de madera (de al menos 16-20 cm por lado)

20 nails

scissors

a hammer

a pencil

a ruler

Étape 1 - Create the weaving loom

Use your pencil and ruler to draw a square 12cmx12cm.

Put 20 nails every 2 cm. With your hammer, firmly plant the nails into the board onto each of the 20 dots.




Étape 2 - Prepare the cloth

Choose a sock that can stretch over 12 cm. 

Use your scissors to cut 10 rings of 4 cm width on your socks.




Étape 3 - Attach the rings

Attach the rings to the nails vertically, only in one side.

Attach 5 rings vertically (see image).

Étape 4 - Weave

Weave the remaining 5 rings horizontally in and out of the vertical rings. Start by attaching a ring to the top left nail on the left side of the square and pass it over the first vertical ring, under the second vertical ring, over, under and over and then hook it to the opposite top right nail on the right side of the square. Attach 4 more rings horizontally, but weaving the opposite way with each new ring: Horizontal rings 2 and 4 would be under, over, under, over, under. (see image).




Étape 5 - Close the loops

Unhook any ring/loop from its nail, then unhook a second loop right next to it. Pass the second loop into the first loop. Hold on to the second loop and let go of the first loop. The second loop now becomes the “first loop”. Continue this step all around your square. Tighten as you go, as needed.

The final loop that you end up with is the hook that you’ll use to hang and dry your tawashi sponge!




Commentaires

Published