Translations:Lampe solaire à batteries lithium récupérées/240/en : Différence entre versions

Version actuelle datée du 25 février 2020 à 17:50

In the cleat, cut out 4 portions of about 20cm. Place them in each corner of one of the already cut small boards (11/13cm) and screw each cleat portion with the board. Place the other small board at the other end of the four portions and screw them in the same way. The result is a cuboid of dimensions 11/13/20, which will be used to thermoform the plastic bottle.

Version du 12 février 2020 à 16:45 (voir la source) GoldofBengal (discussion \| contributions) (Page créée avec « In the cleat, cut out 4 portions of about 20cm. Place them in each corner of one of the already cut small board (11/13cm) and screw each cleat portion with the board. Pla... »)		Version actuelle datée du 25 février 2020 à 17:50 (voir la source) GoldofBengal (discussion \| contributions)
(Une révision intermédiaire par le même utilisateur non affichée)
Ligne 1 :		Ligne 1 :
−	In the cleat, cut out 4 portions of about 20cm. Place them in each corner of one of the already cut small ~~board~~ (11/13cm) and screw each cleat portion with the board. Place the other small board at the other end of the four portions and screw them in the same way. The result is a cuboid of dimensions 11/13/20, which will be used to thermoform the plastic bottle.	+	*In the cleat, cut out 4 portions of about 20cm. Place them in each corner of one of the already cut small boards (11/13cm) and screw each cleat portion with the board. Place the other small board at the other end of the four portions and screw them in the same way. The result is a cuboid of dimensions 11/13/20, which will be used to thermoform the plastic bottle.