Translations:Lampe solaire à batteries lithium récupérées/243/en : Différence entre versions

Version actuelle datée du 14 février 2020 à 11:53

Heat slowly with a thermal stripper each side of the cuboid. The stripper should be approximately 10 cm far from the bottle. Once the bottle obtains the same shape than the mold, continue to heat in order to erase the bottle patterns and to stretch the plastic properly.

Version du 12 février 2020 à 15:50 (voir la source) GoldofBengal (discussion \| contributions) (Page créée avec « Heat slowly with a thermal stripper each side of the cuboid. The stripper should be around 10 cm far from the bottle. Once the bottle obtains the same shape than the mold,... »)		Version actuelle datée du 14 février 2020 à 11:53 (voir la source) GoldofBengal (discussion \| contributions)
(2 révisions intermédiaires par le même utilisateur non affichées)
Ligne 1 :		Ligne 1 :
−	Heat slowly with a thermal stripper each side of the cuboid. The stripper should be ~~around~~ 10 cm far from the bottle. Once the bottle obtains the same shape than the mold, continue to heat in order to erase the bottle patterns and to ~~strech~~ the plastic properly.	+	*Heat slowly with a thermal stripper each side of the cuboid. The stripper should be approximately 10 cm far from the bottle. Once the bottle obtains the same shape than the mold, continue to heat in order to erase the bottle patterns and to stretch the plastic properly.