- Using string, go around the barrel, mark the point at which it meets on the string with a felt-tipped pen: this will give you the circumference of the barrel.
- Fold the string in half and make a new mark half way between: i.e. half of the circumference.
- Draw around the tubes which are to be inserted to mark where you need to make the holes.
- Use string to locate the centres of the 2 apertures opposite each other.
- Cut out the two circles staying well inside the lines.
- Hammer the edge of the hole (towards the outside) in order to fit the tube.
- Keep the cut-out circles to make the stoppers for the ash tray and feed.
Français
English
Deutsch
Español
Italiano
Português